Sportcity dual beam
Hi there. Im new owner of SC. All from fabric runs as i want, i notice a few improvements for it but costs time and ca$h. But the only mod i want to do is real dual beaming. Not to do work two bulbs at same time on lo or hi setup. Just replace h7 on the two optics for two h4 and set it up to work both with first filament on lo beam and runs only the second filament on both when turn hi on.
To start, i questioned about electric power. H4 has 55w and 70w. Normally this bike runs only one bulb of 50w and change it for lo and hi, but only one is working. I readed about the voltage draw with two h7 working doesnt make problems it seems. But do to work two 70w bulbs its 90w more than aprilia mades this bike for. The less important will be the fuse, just put bigger one and full throttle! But, the wiring... I want to believe it will support the watts also... But, will the regulator burns off cause the augment of energy demand?
After answering that questions and suposes, whats about the handmaking? I make this same conversion on z1000 06 and to match the bulb in the hosing, i mod the plates bulb to make bulb matches into hosing, i can repeat the work. Another handwork will be the wiring. Will be right to use the only wire for each beam and do a derivation to the new bulb? In the case on lo beam is pretty little warming for the stock wire, but for the hi (70w) beam, the stock wiring section will support two 70w bulbs? In that case, the work will be harder i think, change all hi beam wiring for a correct section? I dont know... Thats why i expose this all.
Read responses in apriliaforum.com