Forumsee logo
Forumsee » Motorbikes » Technical » Read message
RSS: Subscribe to RSS

Grubee 4g output shaft clearance

Transmission / Drivetrain - www.motoredbikes.com
I'm looking into putting 2 sprockets on my output shaft coming from my grubee 4g 1b transfer case. Correct me if my measurements are off, shaft size is 5/8" with a 3/16 keyway. There is roughly 1 3/4" from the center of the shaft to the engine block and 1 1/2" from the center of the shaft to the air filter box.

I'm thinking about a 10 tooth output matched to a 48 tooth rear (24:1 overall reduction) with a 14 tooth matched to a 44 tooth rear 15.71:1) beside it. Would give me 22mph with hill climbing capability and 34mph for flat ground and downhill at 6870 rpm. Tempted to throw on my old flywheel and magneto for 41mph top speed at 8300 rpm.

According to this chart the 14 tooth should fit:

Does anyone see issues?

 


Read responses in motoredbikes.com

Tags


Last videos:

Super cool YouTube vids...
Super cool YouTube vids...
Fast Harley on The Snake
Fast Harley on The Snake
Sport Glide Saddlebag flaw
Sport Glide Saddlebag flaw
The TRUTH about new bike buyers
The TRUTH about new bike buyers
Videos with Aquatic AV installed
Videos with Aquatic AV installed
Backroading in florida
Backroading in florida
the end of Dynas ...
the end of Dynas ...
Found some 2018 Harley vids
Found some 2018 Harley vids
Cars · 
Mobility · 
Hardware · 
Motorbikes · 
Travel · 
Boating · 
Aviation · 
production-frontend
About Forumsee · Contact · Privacy policy · Request content removal
We use cookies for navigation analysis and personalized advertisement. By using our site, you agree to our use of cookies.
Accept  ·  Learn more